Broccoli Natalino – West Coast Seeds

The NcSTAR AR-15 Ultimate Tool Kit is stored in a padded case and this essential kit has everything you need to work on your M4 carbine, AR-15 rifle, or pistol. This tool kit is perfect for Gunsmiths or any person who repairs, modifies, or builds AR15 rifles. It includes modular AR15,M4 upper receiver and lower receiver vise block constructed from blue hard anodized aluminum for performing work on your upper receiver or use the lower vice block by itself by clamping the lower vice block to a bench vice and attaching the upper receiver to the vice block with the two included 0.25 in receiver cotter less hitch pins. Removing the two outer hex bolts from the lower vice block separates it from the upper receiver block. The upper half of the receiver block slides into the upper receiver like a bolt carrier group. The lower vice block bolts onto the upper receiver block to fully support the inside and bottom surfaces of the upper receiver for installation or removal of a barrel. This prevents the damaging of the upper receiver from distortion, twisting, or bending of the receiver when installation or removal of a stubborn seized barrel nut. This also leaves the outside of your upper receiver completely open and free for mounting optics, sights, and accessories. The upper receiver block also has a hole through the length of the block to act as a bore brush guide for cleaning out the bore of the barrel. This tool kit includes Pro Series AR15 Barrel Wrench, Pro Series AR Lower Receiver Wrench, AR15, M4, M4 A1 and A2 Front Sight Adjustment Tool, AR15, M4 Handguard Removal Tool, and AR15, M4 Magazine Well Lower Receiver Vice Block/Mag Block. It also includes AR15, M4 Hand Tools. Hand tools included are 5/64 in steel punch, 3/32 in steel punch, 1/8 in steel punch, mallet with nylon and brass ends and wooden handle, nylon cleaning brush with broad and narrow bristle brush heads, 1/4 in hex screwdriver with 3/16 in, Philips PH2 and PH3 bits, and flat head no. 6 and no. 7 bits.

• Pro Series AR15 Barrel Wrench: Heavy duty steel barrel wrench works with MIL-SPEC barrel nuts for installation or removal of the barrel and free float handguards with the same hole spacing; 5/8 in wrench on the opposite end for 5/8 in muzzle brakes and flash suppressors
• Pro Series AR Lower Receiver Wrench: Heavy duty steel castle nut wrench for M4 MIL-SPEC and commercial type collapsible stock buffer tubes; 3/4 in wrench on the opposite end for the installation or removal of A2 buffer tubes; Also in and 3/8 in drive ratchet and breaker bar compatible
• AR15 M4 A1 and A2 Front Sight Adjustment Tool Included Works with both A1, 5 prong, and A2, 4 prong, type front sight posts for zeroing your iron sights
• AR15 M4 Handguard Removal Tool: Works with Rifle, Carbine, and Mid-Length handguards; Hook end goes into the magazine well and the two arms slips over the Delta ring for leveraging against the Delta ring spring, for the installation or removal of two piece top and bottom plastic type handguards
• Magazine Well Lower Receiver Vice Block, Mag Block: Can be inserted into the AR-15 5.56 or .223 type magazine wells just like a magazine; Lower receiver can be secured to the mag block if magazine catch assembly IS installed onto the lower receiver
• Includes 5/64, 3/32, 1/8 steel punches for gas tube roll pin, bolt catch roll pin, and trigger guard roll pin; Nylon Cleaning brush with broad and narrow bristle brush heads
• Includes 1/4 inch hex screw driver handle with 3/16 in, Philips PH2 and PH3, and flat head no. 6 and no. 7 bits